Why does my Emerson Gateway keep failing to join the network?
Most join failures occur because of security issues, such as a missing or incorrect join key, or not being on the access control list. To resolve this, first ensure that the connection with EtherNet/IP is established. Then, go to SETUP ? SECURITY ? PROTOCOLS to verify your security settings.
General| Wireless Technology | WirelessHART |
|---|---|
| Operating Temperature | -40 to 70 °C (-40 to 158 °F) |
| Frequency Band | 2.4 GHz ISM Band |
| Power | 10 to 30 V DC |
| Mounting | Wall or pipe mounting |
| Protocols | HART-IP |
| Hazardous Area Approvals | ATEX, IECEx, CSA |
| Wireless Protocol | WirelessHART |
| Enclosure Rating | IP66/NEMA 4X |
| Communication Ports | Ethernet |
Details the Emerson Smart Wireless Gateway 1410's connectivity and capabilities.
Provides guidance on how to use the manual for installation, configuration, and maintenance.
Describes initial connection and settings for the Gateway before network deployment.
Outlines the steps for connecting and configuring the Gateway for the first time.
Details essential settings like passwords, time, and network configuration for the Gateway.
Explains how to configure the Gateway's IP address and other TCP/IP network parameters.
Covers mounting the Gateway and making electrical connections.
Describes how to physically install the Gateway unit onto a DIN rail system.
Details the physical connection types for Ethernet and RS-485 interfaces.
Explains the use of the Gateway's two 10/100base-TX Ethernet ports.
Describes the optional RS-485 serial connection for Modbus RTU communication.
Discusses the installation and setup of optional software for host integration and device configuration.
Lists the PC hardware and operating system requirements for software installation.
Explains how to use the utility to secure industrial protocols and enable encrypted communications.
Guides on connecting the Gateway to a host system and integrating field device data.
Describes physical connection types and protocols for Gateway integration.
Illustrates Ethernet connectivity for various protocols like Modbus TCP and OPC.
Illustrates RS485 connectivity for Modbus RTU protocol.
Covers Modbus RTU and Modbus TCP support for the Gateway.
Details settings required to match the Modbus master or client configuration.
Explains assigning data points from devices to Modbus registers for polling.
Provides contact information for technical support and assistance.
Addresses common problems encountered during the first connection to the Gateway.
Troubleshoots the "page not found" error, usually due to incorrect IP or proxy settings.
Provides solutions for problems with Modbus RTU and TCP communication.
Lists recommended actions when Modbus RTU communication fails.
Details the procedure for returning materials for service or replacement.
Lists key operational parameters like input voltage and current draw.
Specifies the required input voltage range for the Gateway power supply.
Details the operating current draw based on power consumption.
Outlines specifications for RS485, Ethernet, Modbus, OPC, and EtherNet/IP protocols.
Provides details on Ethernet port speed, protocols, and wiring.
Lists available models, configurations, and options for ordering the Gateway.
States compliance with FCC and IC rules for radio frequency emissions.
Covers requirements for installing equipment in the USA and Canada, including Division markings.
Details USA specific certification for Division 2 hazardous locations.
Details Canada specific certification for Division 2 hazardous locations.
To Next Page
