Figure 2-2: Setup → Time Settings
TCP/IP network settings
WARNING
Use caution when making changes to the TCP/IP network settings. If they are lost or
entered incorrectly, the Gateway will require a factory reset (see Resetting to factory
defaults). Contact the network administrator for information on the proper TCP/IP
network settings to apply.
Prior to the Gateway being installed and connected to a live control network, it should be
configured with an IP address, as well as other TCP/IP network settings. This specific page
can be found in System backup.
Reference Manual Configuration
00809-0200-4410 September 2020
Emerson.com/Rosemount 13
To Next Page
Loading...
