Emerson Wireless 1410 Gateway - Configuration; Configuration Overview; Initial Connection and Configuration

2 Configuration
2.1 Overview
This section describes how to connect to Emerson Smart Wireless Gateway 1410 for the
first time and the settings to configure before placing it on a live control network. It is
important to note that some Gateways are used in stand-alone applications and do not
reside on a network. In these cases, it is still important to configure the items outlined in
this section.
Before the Gateway can be permanently mounted and connected to a live control
network, it needs to be configured with an IP address. This is done by forming a private
network between the Gateway and a PC/laptop. The following items are required to
complete this section:
• Gateway
• PC/laptop
• Ethernet cable
• 24 VDC (nominal) power supply
2.2 System requirements
The following requirements apply to the PC/laptop used to configure the Gateway.
Additional requirements may apply if using the Security Setup Utility or AMS
™
Wireless
Configurator. See Commissioning for more information.
Web browser applications
• Microsoft
®
Internet Explorer
®
6.0 - 10.0
Ethernet
• 10/100 base-TX Ethernet communication protocol
2.3 Initial connection and configuration
2.3.1 Prepare PC/laptop
The PC/laptop will need to be configured to form a private network before communicating
to the Gateway. The network settings can be found in the control panel of the PC/laptop
running a Microsoft platform based operating system. To configure these settings:
Procedure
1. Find and open the Control Panel (generally accessed from the Start Menu).
2. Open Network Connections.
3. Select Local Area Connection.
Reference Manual Configuration
00809-0200-4410 September 2020
Emerson.com/Rosemount 7