17
Programmed Playback
The CD player in this unit has a 20 track programmable memory which allows you
to program any disc to play just the tracks you want to hear in the exact order that
you want to hear them. You may program a track or tracks to play more than once
if desired.
Note: Programming can only be done while the player is in the Stop mode. If
a disc is playing press the Stop button to stop playback before performing
the programming steps below.
1.) Turn the unit ‘On’, select the CD function and load the desired disc in the
player. Wait until the player reads the disc and the display shows the total track
number.
2.) Press the PROGRAM button. The PROGRAM indicator flashes and the display
briefly shows “P 01” then “00” flashes indicating that you can select the first
track to be programmed.
3.) Press the or buttons to select the first
track. The desired track number flashes on the
display.
4.) Press the PROGRAM button again. The selected track is entered in program
memory number 01 and the display advances to “P 02” then “00” flashes again
indicating that you can select the next track to be programmed.
5.) Press the or buttons to select the next track to be programmed, andnd
press the PROGRAM button to enter the track in the memory.
6.) Repeat step 5 to program up to 20 tracks in the memory.
To Next Page
Loading...
Need help?
General
