ControlWave Express Instruction Manual (CI-ControlWave Express)
Revised Mar-2011 Installation 2-23
Figure 2-14. Display with No Keypad
Both keypads use the same 4-line by 20-character LCD displays.
The Display without a keypad has a 2-line display with 10 characters on
the first line, and 6 characters on the second line. This display shows
variable values on line 1, and variable names on line 2.
You connect the Display/Keypad or Display to the ControlWave
Express using a cable, one end of which has an RJ-45 jack (connected
into the RJ-45 equipped with two plugs. This cable connects between
the RJ-45 display jack (J2) on the CPU/System Controller board and
RJ-45 jack (J1) on the remote Display or remote Display/Keypad
assembly. A potentiometer, provided on the keypad, allows you to set
the contrast of the LCD display.
Note: For further information on the installation and use of the
optional keypads, refer to the ControlWave Display/Keypad
Manual (D5135).
To Next Page
Loading...