6-1 P7150INT
HOW TO INITIALIZE THE TELEVISION
To put the program back at the factory-default,
initialize the television as the following procedure.
1. Use the service remote control unit.
2. Turn the power on. (Use main power on the TV
unit.)
3. Press [SLEEP] button on the service remote
control unit to enter the Service mode. (Refer to
“How to enter the Service mode” on page 5-1.)
4. Press [VOL n] button on the service remote
control unit twice, and confirm that OSD indication
is “7F = FF.” If needed, set it to become “7F = FF”
by pressing [CH o / p] buttons on the service
remote control unit.
5. Confirm that OSD indication on the four corners
on TV screen changes from on and off light
indication to red by pressing a [DISPLAY] button.
(It takes one or two seconds.)
6. Turn the power off by pressing main power button
on the TV unit, and unplug the AC cord from the
AC outlet.
To Next Page
Loading...
