Page 16
Product Information / Produktinformation
A6151
Shaft Vibration Monitor
Signal outputs EO 1 / EO 2
d14 / d16
voltage output 0 ... 10V. For modes with separate channels according to the characteristic
value. For modes S
max
and S
PPmax
outputs of the single−channel measured values.
Measuring range and evaluation according to the characteristic value.
Depending on the application and configuration the outputs EO can be used for linkage or for
display.
Open circuit and short circuit proof, non reactive.
Nominal range 0 ... +10 V DC
Resolution 8−bit
Per. load resistance > 10 kΩ
Internal resistance Approximately 50 Ω
Signal inputs EI1 / EI2
Inputs for single−channel measurement values 0 ... +10 V for connection with EO outputs.
Voltage input EI1 / EI2 b14 / b16
Nominal voltage range 0 ... +10 V DC
Resolution 10−bit
Input resistance > 100 kΩ
Signal input KEY
The key pulse is required for internal RPM determination for checking the measurements in
the measured value analysis.
Signal input KEY (N) d22
Signal level 24 V logic,: LOW = 0 ... 3 V; HIGH = 13 ... 48 V
Input resistance > 10 kΩ
To Next Page
Loading...
