Emerson EWD7003 - Firmware Renewal Mode

1-11-1 E58T0TEST
FIRMWARE RENEWAL MODE
1. Turn the power on and remove the disc on the tray.
2. To put the DVD player into version up mode, press
[9], [8], [7], [6], and [SEARCH MODE] buttons on
the remote control unit in that order. The tray will
open automatically.
Fig. a appears on the screen.
The DVD player can also enter the version up
mode with the tray open. In this case, Fig. a will be
shown on the screen while the tray is open.
3. Load the disc for version up.
4. The DVD player enters the F/W version up mode
automatically. Fig. b appears on the screen.
The appearance shown in (*2) of Fig. b is
described as follows:
5. After programming is finished, the tray opens auto-
matically. Fig. c appears on the screen.
At this time, no buttons are available.
6. Unplug the AC cord from the AC outlet. Then plug it
again.
7. Turn the power on by pressing the power button
and the tray will close.
8. Press [1], [2], [3], [4], and [DISPLAY] buttons on the
remote control unit in that order.
Fig. d appears on the screen.
9. Press [3] button on the remote control unit.
Fig. e appears on the screen.
10.To exit this mode, press [POWER] button.
F/W Version Up Mode
Please insert a DISC
for F/W Version Up.
EXIT: POWER
Fig. a Version Up Mode Screen
[(*1): previous version No.]
Model: E58T0UD
VERSION: ****(*1)
Fig. b Programming Mode Screen
F/W Version Up Mode
VERSION : FH***L1E
Reading...(*2)
EXIT: POWER
Model: E58T0UD
VERSION: ****
AppearanceNo. State
Reading... Sending files into the memory
Erasing... Erasing previous version data
Programming...
1
2
3 Writing new version data
Fig. c Completed Program Mode Screen
F/W Version Up Mode
VERSION : ********
Completed
SUM : 7ABC (*3)
Fig. d
E58T0UD Ver: **** Region: 1
1: VFD/LED TEST
2: ERROR RATE (FIX MODE)
3: EEPROM CLEAR
4: MEASUREMENT SERVO
5: ERROR RATE (PLAY MODE)
EXIT: POWERRETURN: -----
Fig. e
Ver: ****
TEST 3: EEPROM CLEAR
EEPROM CLEAR: OK
EXIT: POWERRETURN: -----
E58T0UD Region: 1