Emerson Fisher D3 - Parts Ordering; Parts Kits; Parts List

Instruction Manual
D104161X012
D3 Valve with Gen 2 easy-Drive Actuator
February 2021
26
Parts Ordering
Each D3 control valve is assigned a serial number, which can be found on the nameplate. Refer to the number when
contacting your Emerson sales office
for assistance or when ordering replacement parts.
WARNING
Use only genuine Fisher replacement parts. Components that are not supplied by Emerson should not, under any
circumstances, be used in any Fisher valve, because they may void your warranty, might adversely affect the performance
of the valve, and could cause personal injury and property damage.
Parts Kits
TRIM KITS
Port Diameter (inches) 0.375 0.75 1
Standard trim kit (Contains keys 2, 3, 4, and 43) RD3STDX0012 RD3STDX0022 RD3STDX0032
Carbide trim kit (Contains keys 2, 3, 4, and 43) RD3CARBX042 RD3CARBX052 RD3CARBX062
PACKING KIT Contains keys 4, 10, 11, 43, and 44 RD3PACKX012
VALVE STEM Key 16 GE48049X012
LICENSE KEY (5 LICENCES) GE83574X022
CONTROLLER BOARD
UPGRADE/REPLACEMENT KIT (ON/OFF)
GE83055X012
CONTROLLER BOARD
UPGRADE/REPLACEMENT KIT
(POSITIONING)
GE83126X012
GEARBOX REPLACEMENT GE84238X012
Parts List
Note
Recommended spare parts are included in the Parts Kits shown at the
top of this page. Contact your Emerson sales office for Part Ordering
information.
Key Description
1 Valve Body
2* Seat Ring
3* Valve Plug
4* Bonnet O‐ring
5 Bonnet Nut
6 Spring Pin (or alternate pipe plug) (2 req'd)
7 Bonnet
8 Packing Retainer
9 Belleville Springs (5 req'd)
10* Anti‐Extrusion Washer (2 req'd)
11* Packing Set
Key Description
12 Packing Spacer
13 FloPro Half
14 FloPro Half
15 Hex Socket Head Cap Screw (2 req'd)
16* Stem
18* O-ring
20 Locknut
25* Stem O-ring
27 Stem Nut
34 Valve Nameplate
41 Drive Screw (2 req'd)
43* Groove Pin
44* High Performance Fluorinated Grease Packing Lubricant
58 Enclosure O-ring
59 Motor/gearbox/controller assembly
60 Upper Enclosure
61 Lower Enclosure
62 Motor Cap Screws (4 req'd)
63 Motor Cap Screw Washers (4 req'd)
64 Enclosure Cap Screws (8 req'd)
65 Enclosure Cap Screw Retaining Washers (8 req'd)
66 Ground Screw
68 Certification Nameplate
69 easy-Drive Label
*Recommended spare parts