Instruction Manual
D101957X012
V150 and V300 Valves
February 2011
15
Figure 8. Index Mark for Actuator Lever Orientation
NOTE:
1. ARROW ON LEVER INDICATES DIRECTION OF ACTUATOR THRUST TO CLOSE VALVE.
5. Installing the pins (key 7):
CAUTION
The ball might be damaged if it is allowed to hit the flange edge or interior of the valve cavity while it is being lowered into
the valve body.
D Lift the valve and place it on the edge of both flanges. Make sure the ball is in its open position, and in the lower half
of the valve cavity. Block the packing box side of the valve so the drive shaft is horizontal.
D Insert the pin (key 7) into the ball ear and follower shaft until it is flat with the ball ear surface. (Note: the pin does
not extend the full width of the ball ear.
D Refer to the Packing Replacement procedures and install the packing parts as described in that section. Slightly
tighten the packing nuts (key 20).
To Next Page
Loading...
