Instruction Manual
D101957X012
V150 and V300 Valves
February 2011
18
WARNING
Use only genuine Fisher replacement parts. Components that are not supplied by Emerson Process Management should not,
under any circumstances, be used in any Fisher valve, because they may void your warranty, might adversely affect the
performance of the valve, and could cause personal injury and property damage.
Note
Neither Emerson, Emerson Process Management, nor any of their affiliated entities assumes responsibility for the selection, use, or
maintenance of any product. Responsibility for the selection, use, and maintenance of any product remains with the purchaser and
end user.
Parts Ordering
A serial number is assigned to each valve and stamped on the nameplate. Always refer to the valve serial number when
corresponding with your Emerson Process Management sales office regarding spare parts or technical information.
When ordering replacement parts, also specify the complete 11‐character part number from the Parts List.
Parts List
Note
Part numbers are shown for recommended spares only. For part
numbers not shown, contact your Emerson Process Management sales
office.
Key Description Part Number
1 Valve Body Assembly
If a part number is required, contact
your Emerson Process Management sales office.
2 Ball
3 Seal Protector Ring
6 Drive Shaft
7* Pin, S20910 (2 req'd)
NPS 14 13B6896X012
NPS 16 13B0697X012
NPS 20 13B6060X012
9 Follower Shaft
10* Bearing (2 req'd) See following table
11* Ball Seal See following table
13* Wave Spring, N07750 (Inconel)
Use w/HD Metal Seal
NPS 14 23B7013X012
NPS 16 23B0695X012
NPS 20 23B6064X012
15* Gasket, laminated graphite
Standard Construction
NPS 14 13B6894X022
NPS 16 13B0692X022
NPS 20 13B6058X022
Key Description Part Number
Use w/ oxygen service
NPS 14 13B6894X032
NPS 16 13B0692X032
NPS 20 13B6058X032
16* Packing Set, Set includes PTFE V‐ring packing with one carbon‐
filled conductive ring, male adapter, and femaleadapter
NPS 14 12A9057X022
NPS 16 1R5162X0012
NPS 20 1R6699X0012
17 Packing Follower
19 Packing Follower Stud (2 req'd)
20 Packing Follower Nut (2 req'd)
21 Retainer Screw, (used w/B8M)
23 Actuator Mounting Screw (4 req'd)
24 Actuator Mounting Nut, stainless steel (4 req'd)
25 Pipe Plug
26 Identification Nameplate
27 Drive Screw
28 Flow Arrow (2 req'd)
30 Body Size/Serial Number Nameplate,
31 Nameplate Wire (not shown)
35* Packing Ring, graphite ribbon (4 req'd)
NPS 14 12A9140X032
NPS 16 1V949601652
NPS 20 12A9142X012
36* Packing Washer, zinc (Use w/graphite ribbon
packing, 3 req'd)
NPS 14 14A9772X012
NPS 16 12B5927X012
NPS 20 14A9774X012
37* Radial Seal, PTFE/CG/N10276 (alloy 276C)
Use w/HD Metal Ball Seal
NPS 14 13B7012X012
NPS 16 13B0696X012
NPS 20 13B6065X012
*Recommended spare parts
To Next Page
Loading...
