Emerson KTM E0105 Series

To Next Page

Before installation these instructions must be read fully and understood

1 SAFETY PRECAUTIONS

Precautions for using KTM valves safely are

highlighted with the following two warning

signs to indicate the level of danger posed.

Please read the postscript carefully to ensure

safety and prevent any damage before starting

to use the product.

WARNING

A potentially hazardous situation which, if not

avoided, could result in death or serious injury.

WARNING

A potentially hazardous situation which, if not

avoided, may result in minor or moderate injury.

KTM POWDER DISCHARGE SYSTEM (PDS) METALTITE

BALL VALVES

INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS

TABLE OF CONTENTS

1. Safety precautions ......................................... 1

2. Specifications ................................................ 2

3. Range of application...................................... 3

4. Storage and preservation before

installation ..................................................... 4

5. Transportation ............................................... 4

6. Installation ..................................................... 4

7. Operation ....................................................... 5

8. Maintenance .................................................. 6

9. Troubleshooting ............................................ 7

10. Valve disassembly ......................................... 7

11. Warranty ....................................................... 9

Please read through this manual completely

before operating the valves.

Powder Discharge System (PDS) Metaltite

Ball

Valves are usable for ON-OFF powder service

such as polyethylene, polypropylene and

hydrocarbon vapor etc.

Please use the valves according to warnings

and cautions described in this document.

Failure to do so could result in an accident

due to wrong storage, installation, operation,

maintenance and disassembling and/or serious

damage.

Please keep this manual in a handy place for

immediate reference; be sure to provide it to

purchaser, contractor, piping designer, user,

operator or maintenance technician.

KTM reserves the right to discontinue the

manufacture of, change or modify design and/

or construction of any KTM product during the

manufacturing procedure, without incurring

any obligation to accept for credit, to replace or

furnish or install such changes or modifications

on products previously or subsequently sold.

This document is subject to changes without

notice.

Main Page

Need help?

Do you have a question about the Emerson KTM E0105 Series and is the answer not in the manual?

Emerson KTM E0105 Series Specifications

General

Category	Control Unit
Manufacturer	Emerson
Series	KTM E0105
Input Voltage Range	24 VDC (Nominal: 20.4 to 28.8 VDC)
Output Voltage	5 VDC
Output Current	3 Amps
Power Rating	15 Watts
Efficiency	>70%
Operating Temperature Range	-20°C to +60°C (-4°F to +140°F)
Storage Temperature Range	-40°C to +85°C (-40°F to +185°F)
Protection Features	Over Voltage, Over Current, Short Circuit, Reverse Polarity
Cooling Method	Convection
Dimensions	100mm x 70mm x 35mm (3.94in x 2.76in x 1.38in)
Weight	Approximately 200g (7.05 oz)
Certifications	CE, UL, RoHS