16
English
4Use your TV
Switching on your TV and putting it in
Standby mode
To Turn the TV On from Standby or Off to Standby
• Press on the Front panel or the Remote Control.
Adjusting volume
To decrease or increase volume
• Press VOL ɿ / ɽ on the Front panel or press VOL + / ñ on the
Remote Control.
VOL ɿ : Volume Down
VOL ɽ : Volume Up
To mute or unmute sound
• Press on the Remote Control to mute the sound.
• Press again or VOL + / ñ to recover the original sound.
Switching channels
To select Channels by using CH ɾ/ɼ or CH + / ñ
•Press
CH
ɾ (Down) / ɼ (Up) on the Front panel or press
CH + / ñ
on the Remote Control.
To select Channels by using the NUMBER keys
• For Digital channels, press a number followed by a dot “•” and the
corresponding sub channel number.
– When selecting Digital channel 11.1
Be sure to press • before entering the subchannel number.
– When selecting cable or Analog channel 11
Press PREV.CH to return to the previously viewed channel.
Note(s)
• Energy consumption contributes to air and water pollution. When the AC Power cord
is plugged in, your TV consumes energy with a very low Standby Power consumption.
Remote Control
TV
Remote Control
• To select the non-memorized channels, use the NUMBER keys.
• No Signal will appear on the TV screen after the subchannel broadcast is over.
• Audio only program message will appear on the TV screen, when you receive only a
sound signal.
Analog/Cable TV operation
Continued on next page.
To Next Page
Loading...
Need help?
General
