18
ETL Model No.: CF955L
7. Remote Control Procedures (Continued)
7.7: Storage Bracket Installation
A storage bracket is provided for holding your remote
control when not in use. If you desire to use the bracket,
install it on a wall that is away from excess heat or
humidity.
Slide the wall bracket cover up to expose the screw holes
for installation (Figure 32).
Position the bracket on the wall in desired location.
TO INSTALL BRACKET TO
WALL:
SLIDE THE COVER UP TO
EXPOSE THE SCREW
HOLES FOR INSTALLATION
COVER
WALL
BRACKET
SCREW
HOLES (2)
Figure 32
7.8: Storage Bracket Installation
Install the two screws (provided with bracket) into the wall
bracket and tighten to secure to wall (Figure 33).
Slide the wall bracket cover back down over the screws.
TO INSTALL BRACKET
TO WALL:
INSTALL THE TWO SCREWS
SLIDE THE COVER DOWN
WALL
BRACKET
SCREWS (2)
COVER
Figure 33
7.6
To turn the downlight on, press and release the ( )
button. The light will turn on at the light intensity previously
selected (Figure 31).
To vary the intensity of the light, hold the ( ) button down
until the desired light intensity is reached, then release the
button (Figure 31).
NOTE: When turning the light on, power indicator
light on remote control will turn on at the light
intensity previously selected.
Your remote control has full control of your fan and light.
The power indicator light will illuminate while any button is
pressed, indicating that the battery is good.
P
OWER INDICATOR
LIGHT
L
IGHT INTENSITY
BUTTON
Figure 31
To Next Page
Loading...
