Emerson PACSystems RX3i - Add Logic to

Application Guide Chapter 6
GFK-2928C Oct 2019
Updating from a Previous Release 32
6.8 Add Logic to _Main
In the ladder block named _Main, insert a new row at the beginning of the program.
From the Navigator window, select the program block named BUSSES and drag it into the
first rung. This will create a new instance of the block. It will require a name: enter GBusses
for the name.
Zoom into the ladder block named BUSSES to verify that the logic is correct.
•
Zoom into INIT_GB00 and verify that the configuration entries are identical to the
entries in the original application. Repeat for any additional bus pairs that were part of
the original application.
•
Verify that there is an instance of DBUS for each pair of the dual-bus pairs that were in
the original application.