Emerson PACSystems RX3i - Page 16

GFK-2573AD May 2023
14
Subject
Feature
Minimum Version Required
Extended PROFINET device
Subslot Number range
CPE330 Release 8.70
CPU320/CPU315 Release 8.70
CPE310/CPE305 Release 8.70
CRU320 Release 8.70
CPE302 Release 9.40
(Other CPU models are not supported)
RX3i PNC001 Release 2.20
HART Pass-Through
CPE330 Release 8.50
CPU320/CPU315 Release 8.50
CPE310/CPE305 Release 8.50
CRU320 Release 8.50
CPE302 Release 9.40
(Other CPU models are not supported)
RX3i PNC001 release 2.11
(or later)
Hot Standby Redundancy
with PROFINET I/O
CRU320 Release 8.40
CPE330 Release 8.70
(Other CPU models are not supported)
RX3i PNC001 Release 2.00
Hot Standby Redundancy
with PROFINET I/O
CRU320 Release 8.00
CPE330 Release 8.70
(Other CPU models are not supported)
RX3i PNC001 Release 2.00
Non-Hot Standby
Redundancy system
CPU320/CPU315 Release 7.13
CPE310/CPE305 Release 7.10
CRU320 Release 8.00
CPE302 Release 9.40
(Other CPU models are not supported)
PROFINET Controller
version
requirements
Single fiber break
detection
IC695PNC001-Bxxx Release 3.25
IC695CMM002/004
support in IC695PNS001-
Bxxx, IC695PNS001, and
IC695CEP001
IC695PNC001-Bxxx 3.20
Applications using the
IC695CPE302, CPE305,
CPE310, or CPE330
Version 10.05 (or later)
with a PNC001-Bxxx must
also upgrade the PNC to
Version 3.16 (or later) for
compatibility with the
CPE3xx controller.
IC695PNC001-Bxxx: 3.16