Adds support for the Genius Communication Gateway’s
(GCG001) Switch BSM and Enable/Disable Outputs
COMMREQs.
Supports the Remote Get HART Device Information
COMMREQ. Information from a HART device connected
to an RX3i Analog Module in an IC695PNS001 RX3i
PROFINET Scanner may be read into the user application
using the Remote Get HART Device Information
COMMREQ.
Supports extended PROFINET device Subslot Numbers
to support additional 3rd party devices. The maximum
Subslot Number has been increased from 255 to 21845.
Added support for HART
®
Pass-Through feature set over
PROFINET. A HART-capable PROFINET scanner
(IC695PNS001 or IC695CEP001) must also be employed
to support the HART-capable RX3i analog modules over
PROFINET. The CPU used in the application must also
contain firmware that supports HART Pass-Through.
Increased number of PROFINET Devices that PNC001
can control from 64 to 128. Still limited to 63 devices in
an MRP Ring if the PNC001 is the MRP Ring Manager.
Added new SFP OK status bits to existing PNC001 status
dword.
Introduced new Critical Network Port diagnostic fault
configuration and logging. Configuring ports as critical
also forces Copper ports to 100 Mbps.
Adds support for COMMREQs required by the Genius
Communication Gateway (GCG001) module.
Adds remote PROFINET IO to PACSystems RX3i Hot
Standby Redundancy systems. Also adds MRP status
bits.
For details, see New Features and Enhancements
hieronder.
Corrects issue storing PROFINET device configuration
greater than 64K bytes in size.
For details, see RX3i PROFINET Controller IPI, GFK-2573F.
HART
®
is a registered trademark of the HART Communication Foundation of Austin, Texas USA. Any use of the term HART hereafter in this
document, or any document referenced by this document, implies the registered trademark.
To Next Page
Loading...
Need help?
General
