Emerson PNC001-A Series Important Product Information

GFK-2573AD May 2023
11
Version
Firmware
Revision
Date
Comments
IC695PNC001-AE
1.22
Jul 2013
Corrects an issue where, in some configurations, the
PNC001 entered a mode that caused it to repeatedly
power up.
IC695PNC001-AD
1.21
Jul 2012
Addresses a power-up issue affecting the following
revisions IC695PNC001-AB and IC695PNC001-AC.
Although no units that exhibited this issue were shipped,
it is recommended to update the firmware to prevent
the possibility of encountering a power-up issue in the
field.
IC695PNC001-AC
1.20
Mar 2012
Adds support for up to 255 PROFINET IO Devices per
RX3i CPU.
IC695PNC001-AB
1.10
Dec 2011
Adds support for SNMP and LLDP standards to facilitate
network management.
Provides enhanced Revision Information in the Explore
PROFINET Networks tool.
IC695PNC001-AA
1.00
Jun 2011
Initial release.
Supports GSDML Version 2.2 and earlier.
Upgrades
Upgrade Kit: 41G2472-FW01-000-A7
Only IC695PNC001-Bxxx or later revision modules are field-upgradable to this release using the upgrade
kit listed above. IC695PNC001-Ax modules cannot be upgraded with this kit due to hardware and firmware
design changes in the PNC001-Bxxx revision.
Applications using the IC695CPE302, CPE305, CPE310, or CPE330 Version 10.05 (or later) with a
PNC001-Bxxx must also upgrade the PNC to Version 3.16 (or later) for compatibility with the CPE3xx
controller.
Release in line with software license compliance requirements.

Emerson PNC001-A Series Specifications

General

Brand	Emerson
Model	PNC001-A Series
Category	Controller
Language	English