7 Device network configuration
In order to communicate with the Emerson Wireless Gateway, and
ultimately the Information System, the transmitter must be configured to
communicate with the wireless network. This step is the wireless equivalent
of connecting wires from a transmitter to the information system. Using a
Field Communicator or AMS Device Manager, enter the Network ID and Join
Key so that they match the Network ID and Join Key of the gateway and
other devices in the network. If the Network ID and Join Key are not identical,
the THUM Adapter will not communicate with the network. The Network ID
and Join Key may be obtained from the Gateway on the Setup → Network
→ Settings page on the web server, shown in Figure 7-1.
Figure 7-1: Gateway Network Settings
September 2020 Quick Start Guide
Quick Start Guide 27
To Next Page
Loading...