Emerson UNIDRIVE M600 - Page 85

SI-Ethernet User Guide 85
Issue: 1
Safety
information
Introduction
Mechanical
installation
Electrical
installation
Getting started Parameters
Key features
and Protocols
PC Applications Security Diagnostics
Glossary of
terms
Index
6.1.6 Menu 15 – Modbus
This parameter is used to enable or disable Modbus master and slave functionality.
This parameter is used to perform a warm reset of the protocol interface. When set and
the protocol has reset, the parameter will be reset to zero (Off).
This parameter allows the protocol to be defaulted to factory settings. This includes all
of the protocol features, configuration, mappings and stored objects.
S.15.001 Enable
Minimum 0 Maximum 1
Default 1 Units
Type 1 Bit User Save Update Rate Background read
Display Format None Decimal Places 0
Coding RW, BU
S.15.002 Reset
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate
Background read; written to
0 on initialization
Display Format None Decimal Places 0
Coding RW, NC
S.15.003 Default
Minimum 0 Maximum 1
Default 0 Units
Type 1 Bit Volatile Update Rate
On module reset, protocol
interface reset or protocol
enable
Display Format None Decimal Places 0
Coding RW, NC
S.15.004 Modbus Configuration Error
Minimum 0 Maximum 3
Default Units
Type 8 Bit Volatile Update Rate
Module reset, Modbus
interface reset or Modbus
interface enable
Display Format None Decimal Places 0
Coding RO, TE, ND, BU