53
1. Organize all wooden pop’s sticks in the
mold lid, this will make job easier.
2. Fill up the mold cavities.
3. Place the extractor (lid) with wooden sticks
in the mold.
4. Introduce the mold in the vat. Slide the mold
to the right and enter another mold to the left
side and repeat the process. Remove the mold
on right when the product is frozen.
2.3 Filling up the molds
*NOTE: USE ONLY MOLDS APPROVED BY NSF.
MOLDS ARE NOT SUPPLIED WITH THE EQUIPMENT AND THAT EMERYMARK DOES NOT SELL
THEM.
Operation
To Next Page
Loading...