10
Place the base unit on a tripod at an open spot with good reception of GNSS satellites and restart
the Emlid base unit. To achieve the highest level of positioning, leave the base on for several
minutes before starting the rover. When sufficient time has passed, switch on the rover and place
it at least > 10 m away from the base.
Rover configuration
Follow the guide above (Connecting the Emlid Flow app to the Emlid unit) to connect your phone
or tablet to the Emlid Reach RS2 / RS2+ / RS3 unit.
Choose LoRa as correction input and off for correction output.
Follow the guide above (Set up for a single Emlid rover without correction) for settings on the
Positioning streaming (serial, baud rate and format) and the settings on the MALÅ GX and EL WR
Controllers.
To Previous Page
