Assembly of Chassis
WARNING
• Always check that the main locking devices (5) are engaged cor-
rectly before using your pram, it is dangerous to use your vehicle
without these in their correct position.
WARNING
• Always make sure that the main locking device (5) and the button
(6) on both sides clicks into locked position .
• The safety catch(4) (secondary locking mechanism) is activated to
prevent unintentional folding if the chassis locks are not locked into
position.
• Make sure, before you use the pram that both chassis locks are in
locked position.
WARNING
Make sure that children are kept away from moving parts when
assembling the pram, otherwise they might be at risk of injury.
Assembly of Chassis
• Engage the parking device (1). Unfold and extend chassis by pull-
ing up on the handlebar (2) while holding down on the chassis side-
bar (3).
WARNING
• The chassis-locks must click into position
• Make sure the parking device is not engaged. Depress release but-
ton on wheel hub, slide the wheel all the way onto axle. Release
button and pull wheel toward you until you hear a click.
WARNING
• Pull wheel outwards to be sure wheel is locked on.
Repeat the procedure on each of the four wheels.
Attaching Wheels
• Remove plastic protectors from chassis axles.
Save for future use.
IMPORTANT
• Axles may be covered with axle grease, and can leave stains on
fabric.
WARNING
• Choking Hazard - Keep plastic protectors away from children.
To Next Page
Loading...
