Emmaljunga Double Viking - Carrycot Assembly and Usage; Carrycot Frame Assembly; Folding the Carrycot Base

70
Manual Double Viking v. 2.6
1
2
1
1
2
2
1
2
3
1
2
4
5
"Klick""Klick"
3
4
5
6
7
8
Assembly and usage of carrycot
Assembly of pram body
• In order to extend the pram body, slide the metal bar along the
carrycot base until it clicks into one of the plastic recievers.
• Pull one side of each metal bar into position (1) and then the other
side (2) so that both sides clicks into the plastic recievers (3).
• Repeat the same steps with the metal bar on the other side of the
pram body.
WARNING
• Before using the carrycot, make sure that the metal bars have
clicked into all four plastic recievers (3) so that the frame of the
pram body is held rmly in place.
Folding the carrycot
• Lift the mattress.
• Push down the button on the plastic part (4).
• Push the metal bar past the button (5).
• Repeat same steps on all four corners on the carrycot base.
• Slide the metal bars along the bottom and fold the carrycot base.
Assembly of pram body
• Remove plastic covers from mattress and fabrics and discard. The
bottom of the carrycot is made out of wood.
WARNING
• Risk of suffocation. Do not let your children play with the plastic
bag.
• Turn over the backrest (6) to its layback position. (Available on cer-
tain models only)
Adjusting the Backrest (Available on certain models only)
• Raise the backrest (7), push the plastic legs (8) so that it rests
against the metal support bars.