Assembly and usage of seat unit
Assembly of the hood
• Afx both the hood clips on the side of the seat unit.
WARNING
• The hood should be assembled when the pram is in use.
Height adjustment of the hood
• The height of the hood can be adjusted by sliding the hood up and
down on the frame of the seat unit.
• Check that all zips are attached, (ve in total):
− For the wooden plate
− 1 pc under the seat (8)
− 1 pc under the footrest (9)
− 1 on each side of the seat along the black plastic Easy x attach-
ment points (10 and 11).
WARNING
• Before you use the pram, make sure that the seat fabrics are
correctly attached and that all 5 zippers are correctly
fastened.
Removing the hood fabric
• Open the zipper and remove the fabric.
WARNING
• Shearing and Compression points
Note the following when assembling a hood fabric on the aluminium
hood frame. Make sure that the hood frame is assembled as
shown in pictures 9 and 10. Incorrect assembly as shown in picture
11 and 12 can cause shearing and compression points.
This is both for disassembling to wash and changing the hood
fabric.
To Next Page
Loading...
