5
In normal conditions (at a safe distance from sources of interference, such as television sets or
computer monitors) the detection of time signal takes several minutes.
If the weather station does not detect the signal, follow these steps:
1. Move the weather station to another location and try to detect DCF signal again.
2. Check the distance of the clock from the sources of interference (computer monitors or television
sets). The distance should be at least 1.5 to 2 m during the reception of signal.
3. When receiving DCF signal, do not put the weather station in the proximity of metal doors, window
frames and other metal structures or objects (washing machines, dryers, refrigerators etc.).
4. DCF signal reception is weaker in reinforced concrete structures (cellars, high-rise buildings
etc.), depending on the conditions.
In extreme cases, place the weather station close to a window in the direction of a transmitter.
Reception of DCF radio signal is aected by the following factors:
• thick walls and insulation, basements and cellars,
• inadequate local geographical conditions (these are dicult to assess in advance),
• atmospheric disturbances, thunderstorms, electrical appliances with no interference elimination,
television sets and computers located near the DCF receiver.
If the weather station cannot detect DCF signal, time and date must be set manually.
Note: If the weather station detects DCF signal but the current time on the display is incorrect (e.g.
shifted ±1 hour), you must always set the correct time zone for the country where you are using the
station, see Manual Setting of Time.
Manual Setting of Time and Date
1. Long press the SET button.
2. Use the / buttons to set the following parameters: calendar language (EN, GE, IT, FR, DU,
SP, DA) – unit of temperature: °C/°F – DCF signal reception (ON/OFF) – time zone – year – month
– day – time format: 12 h/24 h – hours – minutes.
Conrm each set value by pressing the SET button; holding / speeds up setting changes.
If no button is pressed within 20 seconds, the unit will revert to the basic display.
Alarm Settings
Long press the button; the alarm time will start ashing.
Use the / buttons to set the hour, minute and snooze time delay (5–60 minutes).
Conrm set values by pressing
.
Once settings are nished, the
icon will be displayed automatically. The alarm will then activate
at the set time.
If you wish to deactivate the alarm, press the button followed by . The alarm icon will not be
displayed.
To reactivate the alarm, press the button again.
Snooze Function
You can postpone an alarm by pressing the SNOOZE located on the top of the station.
Press the button when the alarm starts ringing. The icon will start ashing.
To cancel SNOOZE mode, press any other button while the alarm is ringing – the icon will stop
ashing and the
icon will appear on the screen.
The alarm will be re-activated the next day.
If you do not press any button while the alarm is ringing, the ringing will stop automatically after
2 minutes.
Displaying Maximum and Minimum Temperature/Humidity Readings
Press the button repeatedly to gradually display the maximum and minimum readings of indoor
and outdoor temperature and humidity.
The memory of measured values is automatically erased every day at 00:00.
To manually erase the memory of measured values, long press the button.
To Next Page
Loading...
