Emos N1015 - Page 3

3
Charger type: Seven-stage, fully automated charging cycle for lead-acid accumulators.
Three stage, fully automated charging cycle for 4-cell lithium LiFePO₄ 12.8Vaccumu-
lators.
Type of charging control: CC
Power otake from the grid: 300 mA (at full charging current)
Discharging by backfeed current*: < 5 mA
Ripple factor**: < 5 %
Eciency: approx. > 80 %
Stand-by mode: < 1 W
Maintenance current: > 60 mA
Voltage level for evaluating a poor or unsuitable accumulator: < 2 V or > 14 V, for lithium LiFePO₄ 11.6–13.8 V.
Protection against short circuit, overload, overheating and reversed polarity.
Automatic termination of charging.
Maintenance mode.
Charging cable: length 1.8 m – terminals (+ red, – black)
Enclosure: IP65 (charger enclosure)
Operating temperature: 0°C – 40°C (output power automatically decreases at high ambient temperature)
Storage temperature: -30°C – 60°C
Dimensions: 116.2 × 68.4 × 71.3 mm (L × W × H)
Weight: 255 g
*) Discharging by backfeed current is caused by current passing through the connected charger when it is disconnected from
power supply. The EMOS type E-CC008A charger has very low backfeed current of < 1 Ah per month (1 mA/h).
**) The quality of the charging voltage and current is very important. High rippling of the current causes overheating of the
accumulator and accelerates the wear of positive electrodes. High ripping of the voltage can also interfere with other devices
connected to the accumulator. Charger EMOS E-CC008A provides high-quality voltage and current with low ripple factor.
Charger EMOS type E-CC008A is a 7-stage fully automated charger which allows charging of 6 V/12 V lead-acid,
maintenance-free, Super MF, VRLA, UPS and lithium LiFePO₄ 12.8 V accumulators and is capable of switching charging modes.
The E-CC008A is a versatile charger with charging modes for small and medium lead-acid accumulators with capacities
between 1.2 and 30 Ah and lithium LiFePO₄ 12.8 V 4-cell accumulators 2–15 Ah.
Using the most modern technologies allows the charger to charge accumulators to almost 100 % of their original capacity.
It restores slightly sulphated accumulators. It diagnoses and charges discharged accumulators. The charger has a memory.
When power supply cuts out, it remembers the charging mode and continues once power supply is restored.
Operating Instructions
Carefully read the manual and safety information about the vehicle and learn the proper procedure for charging the battery.
Modern vehicles are tted with sensitive electronic components which may become damaged if incorrect technique is applied.
Description of Functions and Icons
Icon Description Meaning LED colour
MODE MODE button Charging mode switch. -
Power indicator Stand-by mode. Green LED
12 V
Charging indicator
for 12 V accumulators
Mode for charging 12 V accumulators. Red LED
6 V
Charging indicator
for 6 V accumulators
Mode for charging 6 V accumulators.
Red LED
12.8 V
LITHIUM
Indicator for charging
LiFePO₄ accumulators
Mode for charging LiFePO₄ 12.8 V
accumulators.
Red LED