Emotron VS10 Instruction

7
Safety instructions
Residual hazards
2.2 Residual hazards
The user must take the residual hazards mentioned into consideration in the risk assessment for his/her
machine/system.
If the above is disregarded, this can lead to severe injuries to persons and damage to material assets!
Product
Observe the warning labels on the product!
Icon
Description
Electrostatic sensitive devices:
Before working on the inverter, the staff must ensure to be free of electrostatic charge!
Dangerous electrical voltage
Before working on the inverter, check whether all power connections are dead! After mains OFF, power con-
nections X100 and X105 carry a dangerous electrical voltage for the time specified on the inverter!
High leakage current:
Carry out fixed installation and PE connection in compliance with EN 61800−5−1 or EN 60204−1 !
Hot surface:
Use personal protective equipment or wait until devices have cooled down!
Motor
If there is a short circuit of two power transistors, a residual movement of up to 180°/number of pole pairs
can occur at the motor! (For 4-pole motor: residual movement max. 180°/2 = 90°).
This residual movement must be taken into consideration by the user for his/her risk assessment.
2.3 Application as directed
•
The product must only be operated under the operating conditions prescribed in this documentation.
•
The product meets the protection requirements of 2014/35/EU: Low-Voltage Directive.
•
The product is not a machine in terms of 2006/42/EC: Machinery Directive.
•
Commissioning or starting the operation as directed of a machine with the product is not permitted until
it has been ensured that the machine meets the regulations of the EC Directive 2006/42/EC: Machinery
Directive; observe EN 60204−1.
•
Commissioning or starting the operation as directed is only allowed when there is compliance with the
EMC Directive 2014/30/EU.
•
The harmonised standard EN 61800−5−1 is used for the inverters.
•
The product is not a household appliance, but is only designed as component for commercial or profes-
sional use in terms of EN 61000−3−2.
•
In accordance with EN 61800−3, the product can be used in drive systems that have to comply with the
categories given in the technical data.
In residential areas, the product may cause EMC interferences. The operator is responsible for taking
interference suppression measures.

Emotron VS10 Specifications

General

Brand	Emotron
Model	VS10
Category	Controller
Language	English