76 Software index Emotron AB 01-3990-11r3
15- Drive Status and Function Reset
Remarks:
*1 can be modified during operation.
*2 cannot be modified during communication.
*3 do not change while making factory setting.
*4 as parameter related to factory setting.
*5 the parameter will be changed by replacing model.
*6 only available in V/F mode.
*7 only for version 2.3 and above.
*8 only for version 2.4 and above.
*10 only for version 2.6A and above
*11 only for version 2.9 and above
14-3 Magnetizing Current (Amps AC) ----- *3*5
14-4 Ferrite Loss Conductance (gm) ----- *3*5
Function
Code no.
Description Range/Code
Factory
setting
Re-
marks
15-0 Drive Horsepower Code (See Instruction manual) *3
15-1 Software Version ----- ----- *3
15-2 Fault Jog (Last 3 Faults) (See Instruction manual) ----- *3
15-3
Accumulated Operation
Time (Hours)
0 to 9999 ----- *3
15-4
Accumulated Operation
Time
(Hours X 10000)
0 to 27 ----- *3
15-5
Accumulated Operation
Time Mode
0000: Time Under Power
0001: Run Mode Time Only
0000 *3
15-6
Reset Drive to Factory
Settings
1110: Reset for 50 Hz
Motor Operation
1111: Reset for 60 Hz
Motor Operation
1112: Reset PLC Program
0000 *4
Function
Code no.
Description Range/Code
Factory
setting
Re-
marks
To Next Page
Loading...
General