All cord connected appliances shall include instructions relative to location of the wall receptacle and a
warning to the user to disconnect the electrical supply before servicing the appliance. Socket needs to
be installed below the cooktop surface, and away from the fire source
Gas Conversion Operating Instructions
Figure 14
1) Air supply valve and cooktop valve need to be closed, unplug the power plug for AC model.
2) When the gas pressure regulator is in NG state and need to be converted to LPG state,
counterclockwise unscrew the end cap under the gas pressure regulator, and then
counterclockwise unscrew the marked NG threaded rod, reverse the threaded rod, turn the LP
arrow upwards and tighten it to the screw cap, then install the cap back to the gas pressure
regulator. The gas pressure regulator gas conversion needs to be used with the accessory kit (See
Burner Configuration for detailed nozzle specifications).
3) Remove the burners, burner caps, and screw out the nozzles from the burner bases. Then install
those nozzles in the Conversion Kit bag to each burner base correspondingly. Save the orifices
removed from the appliance for future use.
4) Input inlet pressure of 11 in wc ( 2740Pa ), coat the nozzle joints and the gas pressure regulator
joints with moderate amounts of soapy water, there shall be no bubbling
5) Place the burner, burner cap, check if the position between the ignition pin and the burner is correct,
and then open the valve, AC model plugged in the power plug.
To Next Page
Loading...
Need help?
General
