13
MAKE ELECTRICAL CONNECTION
This oven is manufactured with a neutral (white) power supply wire and
a cabinet-connected green(or bare)ground wire twisted together.
1. Disconnect power.
2. Feed the flexible conduit from the through the opening in the cabinet.
3. Remove junction box cover, if it is present.
4. Install a UL listed or CSA approved conduit connector to the junction box.
5. Route the flexible conduit from the oven to the junction box through a UL listed or CSA approved
conduit connector.
6. Tighten screens on conduit connection.
7. See “Electrical Connection Options “to complete installation for your type of electrical connection.
To Next Page
Loading...
Need help?
General
