EMS EM250 Series - Page 20

.
SDM MODE
.
.
SDM MODE
.
Select SDM #2, zero the axes and in so doing define the offset co-ordinate of SDM #1.
Define a SDM pattern: (Teach method) Continued…
.
SDM MODE
.
Still on SDM #2, move to the desired SDM #2 co-ordinate.
.
SDM MODE
.
.
SDM MODE
.
.
SDM MODE
.
Select SDM #3, zero the axes and in so doing define the offset co-ordinate of SDM #2.
.
SDM MODE
.
Still on SDM #3, move to the desired SDM #3 co-ordinate.
.
SDM MODE
.
.
SDM MODE
.
.
SDM MODE
.
Select SDM #4, zero the axes and in so doing define the offset co-ordinate of SDM #3.
.
SDM MODE
.
Still on SDM #4, move to the desired SDM #4 co-ordinate.
.
SDM MODE
.
.
SDM MODE
.
.
SDM MODE
.
Select SDM #5, zero the axes and in so doing define the offset co-ordinate of SDM #4.
- 18 -