Emtek CF 2.0 - Door Preparation; Standard Strike Plate Door Jamb Preparation; Strike Plate Installation; Latch Installation

2
English
Step 4C: 

Step 4B: 
1. Door Prep 4. Install Latch




p

1”

Step 4A: 
Alignment Tool
Privacy Funcon: the
threaded hole for the
privacy pin must be
facing the interior side
of the door.
Rotate the nose bolt so that the curved face
will hit the strike plate when closing the door.
!
A B C
  
  
  
NOTE: 
should be used as reference



Door Thickness (A)
2. Standard Strike Plate Door Jamb Prep
3. Install Strike Plate
B
C 1.250
1.125
A
DRILL 1/8”
PILOT HOLES
the strike plate
outline edges and
locate screw holes
on strike with center

1/8" DEEP
13/16" DEEP