Need help?Do you have a question about the Emtek Classic and is the answer not in the manual?
Details required door bore hole dimensions and edge bore.
Instructions for installing security and strike plates on the door jamb.
Steps to install the deadbolt latch assembly into the door.
Procedure for detaching the inside trim plate from the inside chassis.
Guide for positioning and inserting the outside trim plate through the door bore.
Instructions for confirming flat shaft position and installing the inside chassis.
Steps to fasten the inside trim plate using specific machine screws.
General| Strike Plate Included | Yes |
|---|---|
| Handing | Reversible |
| Backset | 2-3/4 inches |
| Material | Solid Brass |
| Handle Style | Lever |
| Finishes | Polished Brass, Oil Rubbed Bronze, Satin Nickel |
| Keyed Alike | Available |
To Next Page
