To Next PageTo Next Page
Need help?Do you have a question about the Emtek CF Mechanism and is the answer not in the manual?
Specifies required door preparation dimensions for bore hole and backset.
Details dimensions for strike plate door jamb preparation based on door thickness.
Fastening the strike plate to the door jamb using wood screws.
Guides through inserting the latch, alignment tool, and securing it with screws.
Ensures privacy pin hole faces the interior side of the door for privacy function.
Mounting the pre-assembled trim with the spindle engaging the alignment tool.
Fastening the CF mechanism to the door edge with machine screws.
Extending the spindle fully and tightening the set screw for secure engagement.
Ensuring the hole in the CF mechanism aligns with the privacy pin hole in the latch.
Placing the rosette onto the door mechanism.
Securing the rosette to the door using the ring fastener wrench.
Sliding the door lever or knob onto the spindle with the plastic washer.
Firmly tightening the pre-installed set screw in the exterior lever or knob.
For privacy locks, screwing the privacy pin through the rosette into the latch.
Using a nail-type object in the release hole to open the exterior rosette.
General
