TAMPING RAMMERS
OPERATION OF THE MACHINE
Transition velocity is slow and vibration weak.
Movement of machine is askew.
• The regulator does not open to the correct velocity of engine (see page 10)
• Insufficient power of engine
• Clutch slips
• Excess of oil on vibrator
• Internal parts of vibrator are defective
Moves forwards or backwards, but cannot switch
• Incorrect fitting of advance or return cable
• Vibrator is jammed
• Parts of motion-direction selector are defective
• Clutch lever incorrectly fitted
Neither moves forwards nor backwards
• Clutch slips
• Vibrator is jammed
• If there is vibration but no movement, it could be that the vibrator is on a moist
or slippery surface. Try on the appropriate surface.
6 IN CASE OF FAILURE
6.1 INTRUCTIONS FOR ORDERING PARTS
1. In all orders placed for parts, THE CODE NO. GIVEN IN THE LIST OF PARTS SHOULD BE
INCLUDED FOR THE PART CONCERNED. It is advisable to include the MACHINE’S SERIAL
NUMBER.
2. The specifications plate with the serial numbers and MODEL are on the top of the engine
plate.
3. Please supply the correct instructions for transport, including the preferred route, address and
complete name of the consignee.
4. Do not return parts to the factory unless you have been given written permission to do so. All
authorized items should be returned carriage paid.
6.2 INTRUCTIONS FOR REQUESTING GUARANTEES
1. The guarantee is valid for one year from the date the machine was purchased. The guarantee
covers the parts with manufacturing faults.
o In no case will the guarantee cover a fault caused by improper use of the equipment.
2. In all requests for guarantees, THE MACHINE SHOULD BE SENT TO ENARCO, S.A. OR AN
AUTHORIZED WORKSHOP, always indicating the complete name and address of the
consignee.
3. The Technical Department (S.A.T.) will notify you f the guarantee has been accepted and, if
requested, can also send out a technical report.
4. No piece of equipment will be covered by guarantee if it has been manipulated previously by
personnel not connected to ENARCO, S.A.
NOTA: ENARCO, S.A., reserves the right to modify any part of this manual without prior notice.
To Next Page
Loading...