Enco Control - Page 8

ENCO Control
Technical description
•Kulautuvos g. 45a , LT-47190 Kaunas •Tel. (+370 37) 360234 •Faks. (+370 37) 360358 •info@axis.lt • www.axis.lt
8
1. HVAC
1.HVAC DHW
2.HVAC - - -
3.HVAC - - -
1. HVAC
1.HVAC DHW
2.HVAC HEAT
3.HVAC VENT
Configuring HVAC system
Choose HVAC type for setting up desired parameters:
1.1. HVAC settings
1. HVAC type DHW
2. HVAC state Auto
3. Recalculation 2
4. Transition 20
5. Integration 30
6. ECO temper. -10.0
7.NIGTH temper. -5.0
8.DAY temper. 0.0
9.Valves settings
10.Pump settings
11.Temper. settings
12.Temperatures
13.Curves
14.Schedule
Field
Description
1.HVAC type
Controller type
2.HVAC state
Operating mode
3.Recalculation
Recalculation time of drive control
4.Transition
Transition time period during which circuit gradually changeovers from
one schedule to another
5.Integration
Integration time
6. ECO temper.
Desired temperature for economic mode
7. NIGHT
temper.
Desired night temperature
8. DAY temper.
Desired day temperature
9.Valves settings
Settings of drive valve control (address)
10.Pump settings
Settings of pump control (address)
11. Temper.
Settings
Settings of the temperature sensors (address)
12.Temperatures
Setting desired temperatures for control
13.Curves
Settings of the heat curve depending on outside temperature
14.Schedule
Weekly schedule of control
By pressing button " " you can to change the value of the selected parameter:
1.1.2. HVAC state
1.Off
2.Manual
3.Auto
4.Aut.Off
5.Economic
6.Night
7.Comfort
DHWRecalculation
Yes No
2
DHWTransition
Yes No
30