WPA-PSK / WPA2-PSK:
If WPA-PSK or WPA2-PSK is selected, user needs to set the key in the
passphrase field as the below screen. The key length should be 8 characters at
least.
Apply: For the changes made to any of the items above to be effective, click
“Apply”. The new settings are now been saved to Access Point and will be
effective once the Access Point restarts.
Note: For entering to the Web Setting page after changing to AP Client mode,
change your PC/Notebook IP address to 192.168.1.x. After changing your
IP address, type 192.168.1.1 on the Web browser to enter the setting of this
Wireless AP.
16
To Next Page
Loading...