Site Survey: This button allows user to enable the Site Survey function to scan
for the available wireless network (wireless clients and Access Points) and
establish wireless communications with one. Selected one of them in list to
establish communications and click “Connect” button.
Authentication Type: The authentication type default is set to Open system.
There are four options: Open system; Shared Key; WPA-PSK and WPA2-PSK.
User may want to set to Shared Key when the clients and AP in the same
wireless network enable the WEP encryption. All the nodes and hosts on the
network must use the same authentication type.
WEP Key: To disable WEP security, click on the “Disable” option. To enable
WEP security, there are 2 types to select – 64bits and 128 bits. When it is
selected, the key value must be entered in ASCII or HEX format.
Note: When WEP security is enabled, all the wireless clients that wish to
connect to the Access Point must also have WEP enabled with the identical
WEP Key value entered.
22
To Next Page
Loading...
Need help?
General
