Endress+Hauser iTHERM TM411 - Page 32

iTHERM TM412
32 Endress+Hauser
!7 (0.28)
3 (0.12)
!D2
!3.2
(0.13)
17 (0.67)
!D2
!3.2
(0.13)
3.2 (0.13)
6.3
(0.25)
!D2
2 31
!D1
!D1
!D1 =
!D2
!D1
!3.3
(0.13)
!6.6 (0.26)
!D1 =
!D2
17 (0.67)
3.2 (0.13)
17 (0.67)
3.2 (0.13)
A0033991
 10 Protection tube tips available (reduced or straight)
Item No. Protection tube (D1) Tip (D2) Insert (ID)
1 6.35 mm (¹⁄₄ in) Reduced tip with 4.76 mm (³⁄₁₆ in) 3 mm (0.12 in)
2 9.53 mm (³⁄₈ in)
• Reduced tip with 4.76 mm (³⁄₁₆ in)
• Straight tip
• 3 mm (0.12 in)
• 6.35 mm (¹⁄₄ in) or
6 mm (0.24 in)
3 12.7 mm (¹⁄₂ in)
• Reduced tip with 4.76 mm (³⁄₁₆ in)
• Straight tip
• 3 mm (0.12 in)
• 6.35 mm (¹⁄₄ in) or
6 mm (0.24 in)
It is possible to check the mechanical loading capacity as a function of the installation and
process conditions online in the TW Sizing Module for protection tubes in the Endress+Hauser
Applicator software. See 'Accessories' section. →  35