Installation Liquistation CSF33
16 Endress+Hauser
4.2 Installation
4.2.1 Connecting the suction line at the side on version with pump
1. When installing the device, take the installation conditions into account.
2. Route the suction line from the sampling point to the device.
3. Screw the suction line onto the device's hose connection.
4.2.2 Connecting the suction line from the bottom on version with pump
If the suction line is connected from below, the suction line is routed upwards behind the rear
panel of the sample compartment. First remove the rear panel of the dosing compartment and
sample compartment as described in the "Electrical connection" section.
1. Remove the drain plug from the hose gland located at the back of the device base.
2. As illustrated, guide the suction line upwards and through the opening towards the
front.
A0013704
5 Sample supply from below
1 Gland for the suction line
2 Suction line
To Next Page
Loading...
