Endress+Hauser Tankvision NXA820 - Configuration of an Isolated Tank Scanner NXA820

Tankvision configuration
37
7.3 Configuration of an isolated Tank Scanner NXA820
Login to the Tank Scanner NXA820 and perform the following configurations (for details refer to
BA339F "Tankvision NXA820, NXA821, NXA822 - Description of Instrument Functions"):
1. Tank Configuration
a. In the navigation tree, click the ’Tanks’ header.
b. In the main screen, select the tank you are going to configure and click the MODIFY
button.
c. Click the individual headers of the tanks menu (’General Details’, ’Capacity Details’, ...)
and configure the parameters.
For a description of the parameters refer to BA337, Chapter 3.
2. Field Scan Configuration
a. In the navigation tree, click the ’System’ header.
b. Click ’Global Settings’ (below the ’System’ header).
c. In the main screen, click the ’Field Scan’ header.
d. Click the individual headers of the Field Scan menu and configure the parameters
2)
.
For a description of the parameters refer to
– BA339F, Chapter 12.5 (Modbus)
– BA339F, Chapter 12.6 (V1)
e. Click the ’Start/Stop Field Scan’ tab and then click on START. Field Scanning is now active.
3. Product Configuration
a. In the navigation tree, click the ’Products’ header.
b. Click the ADD button to add a new product.
c. Click the individual headers of the ’Products’ menu (’General Details’, ’Volume Correction
Factor’, ...) and define the product properties.
For a description of the parameters refer to BA337, Chapter 7.
4. Customer Settings and Environment Settings
a. In the navigation tree, click the ’System’ header.
b. Click ’Global Settings’ (below the ’System’ header).
c. In the main screen, click the ’Customer Settings’ header and configure the parameters.
For a description of the parameters refer to BA339F, Chapter 12.1)
d. In the main screen, click the ’Environment Settings’ header and configure the parameters.
For a description of the parameters refer to BA339F, Chapter 12.3)
5. Product-tank assignment
a. In the navigation tree, click the ’Tanks’ header.
b. In the list below the ’Tanks’ header select a tank.
c. In the main screen click the ASSIGN PRODUCT tab (If necessary use the ’<<’ or ’>>’
button to find the ASSIGN PRODUCT tab.
d. Select the product from the drop-down list.
e. Click SUBMIT to save the settings.
!
Note!
For details about tank-product assignment refer to BA339F, Chapter 7.8
6. Additional Settings
Depending on your requirements, you can perform numerous further settings. For details refer
to BA339F.
2) The parameters can only be edited if the field scan is not currently active. If necessary, go to the ’Start/Stop Field Scan’ tab and stop the field scan.