Setting/Service Guide
38
Maintenance menu:
1) Remove the safety key and press SPEED and ENTER keys at the same time then re-
turn the safety key until “ENGINEERING MODE” is displayed, press ENTER again.
2) You can now scroll through the menu using the UP /DOWN or FAST/SLOW keys. Use
the ENTER key to run. Use the STOP key to return to previous menu selection. The menu
selections are:
1) Key Test – Press each key to verify it is functioning correctly. Press ENTER key to
run.
2) Display test - Lights all LED lights. Press ENTER key to run.
3) Functions (Press ENTER key into this function)
i. Sleep - Turns sleep mode on or off. When off, display is always lit.
ii. Pause - Turns pause mode on or off. When on, Pause lasts 5 minutes.
iii. Maintenance – Reset odometer reading.
iv. Units - Set display to English or Metric readings
v. Grade Return (GS Mode) - Returns the elevation to lowest setting when pause is
pressed
vi. Beep – Turns the speaker (beep sound) on or off.
4) Security – Sets the Child Lock function. This function locks out the keypad until a
pre-determined key sequence is pressed. When “Child Lock” is on, at the time
power is on and before idle mode, MW will displays “CONSOLE LOCKED” you
must press numeric key 0 and Enter at the same time to unlock console and return
to idle mode.
5) Press STOP key to exit and return idle mode.
Setting mileage lock:
1) Remove the safety key, press and hold numeric keys 1, 2, 3 at the same time then
return the safety key to enter setting function.
2) Message window will display “LOCK SETTING = ON/OFF”.
3) Press FAST/SLOW/UP/DOWN keys to set On or Off then press ENTER.
4) If Off is set, it returns to idle mode. If On is set, it enters code setting procedure.
5) Now message window will display “PASSWORD= XXXX”. Use numeric keys in
order to set a 4-digit security code. Press ENTER when complete.
6) Enter the code again to conrm. Press Enter when complete.
7) Now message window will show “MILEAGE XXX Km”. Use UP/DOWN or FAST/
SLOW keys to set the required mileage. Press ENTER when complete. Now
MW window will show “Lock Setting OK” and return to idle mode.
8) To unlock, press and hold numeric keys 1, 2, 3 at the same time to enter unlocking
function.
To Next Page
Loading...
