Enduro SD260 - Adjustment of the Quick Connector; Accessory (not included)

65
ADJUSTMENT OF THE QUICK CONNECTOR
Carry out this maintenance operation only if the bike carrier cannot be fitted
firmly to the trailer coupling, as described in the chapter “Fitting the bike carrier
to the trailer coupling”.
Remove the bike carrier from the trailer coupling, as described under
“Dismantling the bike carrier”.
 Loosen the locking nut slightly (fig. 1).
 Screw in the setting screw one quarter of a turn (fig. 1).
 Tighten the locking nut (fig. 2)
 Check whether the carrier is now firmly seated on the trailer coupling, as
described under “Fitting the bike carrier to the trailer coupling”. If not, repeat
the above steps.
ACCESSORY (not included)
With the optional ride-on ramp you can simply drive your bicycle on the bike
carrier without lifting.