ML0068-001-02 Container Eject System ENERCON INDUSTRIES
1
SECTION 1 – INTRODUCTION
WARNING
Please read carefully before installing or servicing.
HIGH VOLTAGE is present within the control box enclosure. Install according to local electrical codes to
insure personnel safety. When
SERVICING, technician must insure that external electrical power is
disconnected and locked out before making contact with the equipment.
As with any piece of
ELECTRICAL equipment, one should become familiar with the manual and all
associated drawings furnished before applying power. Proper connections and operation are required for safe
use.
FOLLOW INSTRUCTIONS for safety of personnel when operating or maintaining this equipment.
SAFETY AND WARNING
Before you install this Eject System, you should
take the time to carefully read all the instructions
contained in this manual.
Before installing, wiring, starting, operating or
making any adjustments, identify the components
of the Eject System, using this manual as a guide.
The operator should use common sense and good
working practices while operating and maintaining
this unit. Check the safety devices following the
procedures contained in this manual.
Qualified personnel, adequately equipped with
proper tools should do maintenance. Follow the
maintenance schedules as outlined in the manual
to insure problem free operation after start-up.
Safety instructions in this manual are bold-faced for
emphasis. The signal words WARNING and
CAUTION are used to indicate hazard seriousness
levels as follows:
*** CAUTION ***
Caution is used to indicate the presence of a
hazard, which will or can cause minor
personal injury or property damage if the
caution is ignored.
*** WARNING ***
Warning is used to indicate the presence of a
hazard which can cause severe personal
injury, death, or substantial property
damage, if the warning is ignored.
To Next Page
Loading...