ML0068-001-02 Container Eject System ENERCON INDUSTRIES
2
GENERAL
The Enercon Eject System was designed to provide
the packaging industry with a simple system to
eject bad containers off a conveyer. The eject
system can be used with any “bad container”
detectors, such as; missing foil detectors, high cap
detectors and missing cap detectors to name a few.
The system accepts a contact closure from the
desired “bad container” detector which starts a
delay timer. Once timed out, the eject timer is
activated, causing the plunger to eject the container
off the conveyor.
EJECT SYSTEM FEATURES
a. Delay timer
Used to set the time from when the bad
container is detected to when the container
reaches the eject zone.
b. Eject time
Used to set the time for how long the eject
plunger is activated.
c. Cylinder speed adjust
Used to set the extension and retraction
speed of the plunger .
d. Air pressure regulator and gauge
Used to set the force of the plunger.
EJECT SYSTEM SPECIFICATIONS
Electrical
a. A power cord is supplied for customer
connection to a local power source. The
power required is either 120VAC or 240VAC ±
10%, 50/60 Hz, 1ph, 2A. Check rating plate of
eject system for correct voltage.
b. A 12ft. two conductor cable is also supplied
for the external signal input.
Air requirements
a. Filtered air is required at 70-90 PSI.
*** WARNING ***
BE SURE ALL POWER IS DISCONNECTED AND
LOCKED OUT FROM UNIT BEFORE PERFORMING
ANY PREVENTATIVE MAINTENANCE PROCEDURES.
To Next Page
Loading...