THIS DOCUMENT CONTAINS CONFIDENTIAL INFORMATION PROPRIETARY TO ENERGATE INC. NO PART OF ITS CONTENTS MAY BE DISCLOSED OR CONVEYED TO,
USED BY, OR COPIED TO A THIRD PARTY WITHOUT PRIOR WRITTEN CONSENT BY ENERGATE INC. PRINTED COPIES WILL BE CONSIDERED UNCONTROLLED.
AW000873-G 55
6. In the list of homes, for the appropriate home, under Actions, click Provision.
7. On the Provision Devices Details page, click Provision New Gateway.
8. On the Provision New Gateway page, from the Gateway Type list, select ZIP Connect, Wi-Fi or the appropriate
meter type depending on the type of gateway being used
9. Beside the MAC Address or Serial Number field, click the search button.
10. Do one of the following:
For ZIP Connect and Foundation with a Wi-Fi module, enter all or part of the MAC address. Alternatively, you
can enter all or part of the Install Code or Description.
For a meter, enter all or part of the serial number. Alternatively, enter all or part of the Description.
11. Click Search.
If no record of the device is found, try entering the search criteria again or use different search criteria.
If the device is still not found, it may need to be imported into the system. Instructions for importing devices into
LMS are included in the Load Management System Guide.
12. In the search results, click the device to select it, and then click Select.
On the Provision New Gateway page, the information for the device is displayed.
13. Enter a name for the device and, optionally, a description. Then click Submit.
14. To confirm the gateway is online, navigate to the Provision Devices Details page. Then, in the information for the
gateway, click Status.
In most cases, the gateway comes online immediately. However, in some situations it can take a few minutes.
If gateway status information is displayed, the gateway is online and ready to have devices connected to it.
If the status information indicates that the gateway is offline, see 12.2 Troubleshoot Provisioning a Gateway.
11.1.2 Provision Thermostat Communication with a ZigBee Gateway
1. Obtain the thermostat’s MAC address from one of the following three locations:
The thermostat box label.
The radio module on the back of the thermostat. (For some models, you must remove the mounting
bracket to see the radio module’s label.)
The ZigBee Link Info screen. (To access the Link Info screen, in the Installer Setup menu, select ZigBee and
then Link Info.)
2. Use the website provided by the electric utility to provision the thermostat. This process associates the MAC
address of the thermostat with the ZigBee gateway for the home.
To Next Page
Loading...
