ENERGY KINETICS Ascent Combi - General Assembly

Ascent Combi and Ascent Plus Combi Gas – January 2024 13
GENERAL ASSEMBLY
Assembly of various packaged units is illustrated in figure 2A and 2B as well as throughout this manual. The use of non-
Energy Kinetics supplied pump, controls and accessories should follow good practices. The diagrams and locations
presented in the manual are recommended.
Ascent Combi EK1T
For Conventional Venting
Ascent Plus Combi EK1T+
For Polypropylene Venting
Air Vent and T&P Gauge
(behind inducer on the Plus)
Inducer, Outlet accepts 3” Polypropylene
Vent Pipe. Vent pipe installs without the
need for a se
p
arate a
pp
liance ada
p
tor
Ascent Hydrostat
#18 Plate Heat Exchan
g
er
Mix Valve
ASSE 1017 Compliant
Boiler B
yp
ass Strainer/Drain
Domestic Clean-in-place
Fittings. (Optional)
Domestic/Boiler Bypass
Circulator
Figure 2A
Domestic Flow Switch