Ascent Combi and Ascent Plus Combi Gas – January 2024 6
RECORD OF INSTALLATION
INSTALLER NAME:
INSTALLER ADDRESS:
INSTALLER CITY, STATE:
DATE INSTALLED:
NOTES:
SCOPE
This manual covers the Energy Kinetics Ascent Combi Boiler and Ascent Plus Combi boilers. These boilers are
designed and equipped and have been tested to generate hot water in a low pressure closed loop system. The boiler is a
major component of a closed loop system that can be used as a heat source for hydronic, radiant, domestic hot water, spa,
and/or pool heating systems. Call Energy Kinetics to obtain piping and wiring instructions for applications, such as hydronic
heating, radiant heating, domestic hot water, swimming pool heating, multiple boilers, primary/secondary injection loops,
etc. The installer of the system is responsible for the final design of the system and for adding the balance of the needed
parts to complete the system.
COMMONWEALTH OF MASSACHUSETTS
When the boiler is installed within the Commonwealth of Massachusetts:
This product must be installed by a licensed plumber
If antifreeze is used, a reduced pressure backflow preventer device shall be used.
INSTALLER NOTE:
ALL INSTALLATIONS MUST BE MADE IN ACCORDANCE WITH ALL NATIONAL, STATE AND LOCAL,
PLUMBING, HEATING AND ELECTRICAL CODES THAT MAY DIFFER FROM THIS MANUAL AND IN
ACCORDANCE WITH THE FOLLOWING CODES, AS APPLICABLE:
N.F.P.A. No. 70: National Electrical Code A.N.S.I. / N.F.P.A. No. 211: Chimneys, Fireplaces, Vents and Solid Fuel
Burning Appliances A.N.S.I. Z223.1/N.F.P.A. No. 54: National Fuel Gas Code If this gas-fired boiler is converted
to oil-fired by field mounting a listed oil conversion burner, then install in accordance with A.N.S.I./N.F.P.A. No.
31: Installation of Oil Burning Equipment.
These codes are available from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02269-9101.
A hot water boiler installed above radiation level or as required by the Authority having jurisdiction, must be
provided with a low water cutoff device.
A boiler should be installed in such a manner that, if the pressure vessel or any connection thereto should leak,
the resulting flow of water will not cause damage to the area in which it is installed.
A hot water storage tank should be installed in such a manner that, if the storage tank or any connection thereto
should leak, the resulting flow of water will not cause damage to the area in which it is installed.
A boiler’s pressure relief valve, hot water storage tank T&P relief valve, backflow preventer, and all other
devices must be piped to the nearest drain to avoid damage in the event the valve is actuated.
Make sure relief discharge pipes from all reliefs are properly placed to safely contain discharge. Make sure
relief discharge pipes, such as from a boiler or a hot water storage tank, will safely contain hot water and/or
boiling water. Make sure relief discharge pipes, such as from a boiler or a radiant heating system, will safely
contain water treated with boiler chemicals and/or antifreeze. Reliefs include the boiler pressure relief valve, the
back flow preventer discharge port, and the domestic hot water tank temperature and pressure relief valve. Any
other reliefs, such as from radiant heating systems, must also follow these guidelines.
To Next Page
Loading...
