POWERFUL SOLUTIONS. GLOBAL FORCE.
Instruction Sheet
Repair Parts Sheets for this product are available from the Enerpac web site at
www.enerpac.com, or from your nearest Authorized Enerpac Service Center or
Enerpac Sales o ce.
1.0 IMPORTANT RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage. Shipping damage is not
covered by warranty. If shipping damage is found, notify carrier at once. The
carrier is responsible for all repair and replacement costs resulting from damage
in shipment.
SAFETY FIRST
2.0 SAFETY ISSUES
Read all instructions, warnings and cautions carefully. Follow
all safety precautions to avoid personal injury or property
damage during system operation. Enerpac cannot be
responsible for damage or injury resulting from unsafe product use, lack of
maintenance or incorrect product and/or system operation. Contact Enerpac
when in doubt as to the safety precautions and operations. If you have never
been trained on high-pressure hydraulic safety, consult your distribution or
service center for a free Enerpac Hydraulic safety course.
Failure to comply with the following cautions and warnings could cause
equipment damage and personal injury.
A CAUTION is used to indicate correct operating or maintenance procedures and
practices to prevent damage to, or destruction of equipment or other property.
A WARNING indicates a potential danger that requires correct procedures or
practices to avoid personal injury.
A DANGER is only used when your action or lack of action may cause serious
injury or even death.
WARNING: Wear proper personal protective gear when operating
hydraulic equipment.
WARNING: Stay clear of loads supported by hydraulics. A cylinder,
when used as a load lifting device, should never be used as a load
holding device. After the load has been raised or lowered, it must
always be blocked mechanically.
WARNING: USE ONLY RIGID PIECES TO HOLD LOADS. Carefully
select steel or wood blocks that are capable of supporting the load.
Never use a hydraulic cylinder as a shim or spacer in any lifting or
pressing application.
DANGER: To avoid personal injury keep hands and feet
away from cylinder and workpiece during operation.
WARNING: The system operating pressure must not exceed the
pressure rating of the lowest rated component in the system. Install
pressure gauges in the system to monitor operating pressure. It is your
window to what is happening in the system.
CAUTION: Avoid damaging hydraulic hose. Avoid sharp bends and
kinks when routing hydraulic hoses. Using a bent or kinked hose will
cause severe back-pressure. Sharp bends and kinks will internally damage the
hose leading to premature hose failure.
Do not drop heavy objects on hose. A sharp impact may cause
internal damage to hose wire strands. Applying pressure to a
damaged hose may cause it to rupture.
IMPORTANT: Do not lift hydraulic equipment by the hoses or swivel
couplers. Use the carrying handle or other means of safe transport.
CAUTION: Keep hydraulic equipment away from fl ames and
heat. Excessive heat will soften packings and seals, resulting in
fl uid leaks. Heat also weakens hose materials and packings. For
optimum performance do not expose equipment to temperatures of 65°C [150°F]
or higher. Protect hoses and cylinders from weld spatter.
DANGER: Do not handle pressurized hoses. Escaping oil under
pressure can penetrate the skin, causing serious injury. If oil is
injected under the skin, see a doctor immediately.
Index:
English. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1-7
Français . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 -14
Deutsch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15-21
Italiano. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .22-28
Español . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29-35
Nederlands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .36-42
Portuguese . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .43-49
Finnish . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .50-56
Norwegian . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .57-63
Swedish. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .64-70
中文 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .71-77
日本語 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .78-84
L4070 Rev. A 03/13
TQ-700 Classic Bolting Pump
1
To Next Page
General
